How To Use Clipper Brush To Clean

How To: Make clean Clippers, Trimmers & Shavers

Mar 29. 2020 past Shaver Shop Team

It's never been more important to keep your hygiene in check including your everyday grooming devices. Follow these steps for the quickest and easiest ways to help have care of these tools.

Cleaning your shaver, trimmer or clipper

To maintain optimum performance and cleanliness, the Baby-sit Shaving range helps to sanitise and lubricate your shaver, trimmer and/or clipper.

Wash your hands before yous begin.
Make sure your grooming tool is turned off.
Remove the head from your tool and utilise your cleaning castor to sweep away any hair and skin build up. If you cannot remove the head, you tin castor the blade expanse.
Rinse the head under your tap to wash away any backlog peel, pilus and/or oil.Note: If your tool is waterproof, yous can run the caput under your tap.
Dry the head of your device and identify the head back on your tool.
Spray your shaver with Shaver Guard+, Clipper Guard or Trimmer Baby-sit. This will sanitise your shaver head killing any germs and lubricate your blades so they are fix for your next shave. If yous don't have whatever of the Guard Shaving products, we recommend using clipper oil on your clipper or trimmer. Concur your tool on the side and identify a drop or two of clipper oil onto the blade expanse and run your device for a few seconds to distribute the oil.

Irresolute your blades

Each blazon of shaver has a different procedure when changing your blades. Read on for some piece of cake instructions to follow.

Rotary shavers:

Make certain your shaver is turned off.
Pull the shaving head holder off the body of the shaving unit.
Twist the rotating rings inside your shaver head holder and pull them out one past one.
Remove the shaving heads from the shaving caput holder.
Each shaving head consists of a cutter and a guard. Please proceed in mind that the cutter and guard get used to working together and create their own track. Therefore, make certain you continue them grouped every bit a pair together to avoid mixing them upwards. Put the new shaving heads into the shaving head holder.
Reattach the shaving caput holder to the lesser part of the shaving unit of measurement.
Spray your shaver with Shaver Guard+ to sanitise and lubricate the blades.

Foil shavers:

For shavers with a i-piece caput:

Grasp the sides of your shaver and pull the foil to remove the shaver head. The foil and cutters for these models is combined in a cassette-type head, and then there is no need to take this apart.
Slot your new head directly on top of your shaver.

For shavers with a 2-part head:

Remove the foil, past pressing either the release button on the side. If your shaver doesn't have 1, but pull the foil.
Rotate the cutter block past 90 degrees and pull information technology off, holding it at the ends to avoid touching the blade. It is important to not pull out the blades when in a cutting position. This tin harm the drive shaft that the blades sit down in, which can bear on the performance of the shaver.
To fit your new blade, lightly push button the cutter block back onto the base. Then, push button the foil onto the shaver until y'all hear a 'click'.
Spray your shaver with Shaver Baby-sit+ to sanitise and lubricate the blades.

If yous take any questions about the recommended cleaning or blade replacing procedure, our friendly client service team can exist contacted via phone 1300 SHAVER (OR 1300 742 837) or e-mail at back up@shavershop.com.au